Service Messages - GE Interlogix Aritech CS250 User Manual

MESSAGE WHY
Battery Ld Fault The standby battery for the control panel is not working properly.
Battery Vt Fault The standby battery for the control panel is not working properly.
Bus Tamp There has been interference with the connection wire to a keypad
or expansion device.
EEPROM Hd Error The control panel memory is not working properly.
EXPN Lid Tamp There has been interference with the casing of the wireless receiver
or zone expander.
Ext Bell Tamp There has been interference with the external siren.
Ext Tamp There has been interference with a device outside the control panel.
Fire Reset Reqd The fire detector must be reset.
Fuse Ft Aux The fuse of the auxilary power supply has burnt out.
Fuse Ft Battery The fuse in the battery charging circuit has burnt out.
Int Bell Tamp Fl There has been interference with the internal siren.
Keypad Tamp There has been interference with a keypad casing.
Line Fault The telephone line is faulty or is not connected properly.
Local Tamp There has been interference with the control panel casing.
S
ERVICE MESSAGES
G
LOSSARY
ACTION
Contact the installer.
Contact the installer.
Contact the installer.
Contact the installer.
Check the casing. If there is no damage, close
the lid securely.
Check the siren and its connection. If there is
damage, contact the installer.
Contact the installer.
See page 17 for information.
Contact the installer.
Contact the installer.
Check the siren and its connection. If there is
damage, contact the installer.
Check the casing. If there is damage, contact
the installer.
Ensure the line is connected and there is
no problem with the service provider.
Check the casing. If there is no damage, close
it securely.
CS250 User Manual 29