Keypad Functions; Arming Your System In The "Away" Mode; Making Your System Ready To Arm - GE NetworX NX-148E User Manual

KEYPAD FUNCTIONS

III.

ARMING YOUR SYSTEM IN THE "AWAY" MODE

AWAY is utilized when the user is going away from the premise and wants the interior
protected. Listed below are the steps to arm in the AWAY Mode:
Step 1 Close all protected doors and windows.
Ready light will be on or flashing
when all protected zones and
sensors are secure. NOTE: If
any zones are bypassed, a
sensor in that zone can be
violated without affecting the ready light.
The security system will not
arm if the ready light is off.
Refer to "Making Your System
Ready to Arm".
If the power light is off, you
have no AC power. Restore power if possible. If not, contact the
installing company.
Step 2 Enter your 4 or 6 digit user code to arm the system.
The armed and exit lights will illuminate.
You may now leave the building.
The exit light will flash rapidly for the last 10 seconds of the exit delay as a warning
to the user that the exit time is about to expire. The user may wish to disarm and
rearm the system if more time is needed.

MAKING YOUR SYSTEM READY TO ARM

If the ready light is not on or if it is flashing, a zone is not secure. To identify this zone,
use the scroll keys •
that are not normal. If you wish to bypass or unbypass one of these zones, press the
[BYPASS] key while that zone is being displayed. When finished viewing the zones,
WWW.DIYALARMFORUM.COM
press the # key to return to the code entry screen.
NX-148E LCD Keypad
IMPORTANT!
– to the right of the display to browse through the zones
System Ready
Type Code to Arm
System Not Ready
For help, press º
System Armed
All Zones Secure
5