Specifications - North Star SAPPHIRE Operating Manual

1. STBY Standby on/off
2. DISC OPEN/CLOSE.
3. SCAN Play 10 seconds of each track.
4. PROG a. Set the CD player in STOP MODE. b. Select tracks with the numeric buttons, or step to
the number using buttons > or < c. Press the PROG button - the track is programmed. Repeat b
and c until all the tracks you wish to program is done. After each track is programmed, the total
playtime will be shown in the display. If a track with number higher than 13 is programmed, the total
playtime will not be shown. You can browse through the tracks with the buttons > and <. On the
tracks that already are programmed, you will see a «P» shown in the display. If you wish to remove
a track from your program, choose the track number and press PROG. To monitor what is being
programmed. Go back to STOP MODE. Press PROG - The display will now show the programmed
tracks in the new order. The tracks are now stored in the order you programmed them and not in
the original numeric order. If you press STOP two times your program sequence will be erased.
5. FAST Activate before search for faster search.
6. << Search backwards
7. A/B Repeat a segment of the disc/track. Press the button once to mark the start Press it again at
the end of the desired sequence. The selected area will playe continuously until the STOP button is
activated.
8. SHUF Tracks will be played in a random order.
9. REP Press this button once and all the tracks will be repeated. The display will show «REPEAT».
Press the button again, and it will only repeat the current track. The display will show «REPEAT 1»
10. PAUSE On/off.
11. 0-9 Press these buttons to select a specific track on the disc. For track 10 and above, the se
second digit of the number must be pressed within one second.
12. TIME Elapsed time of current track is continuous displayed. First activation will display
remaining time of disc. Next press will show total time of loaded disc.
13. >> Search Forward
14. Next Track
15. Previous Track
16. Play
17. Stop
Replacing remote control batteries
Replace used batteries by gently inserting your fingernail or small screwdriver in the groove on the
left side of the battery compartment cover. Lift the cover off, and insert a fresh set of batteries. Be
careful to follow the + and – polarity indications at the bottom of the battery compartment. Battery: 2
x LR03 / AAA: 1.5Volts.
FREQUENCY RESPONSE
DYNAMIC RANGE
OUTPUT LEVEL
THD+NOISE
OUTPUT IMPEDANCE
OUTPUT UNBALANCED
OUTPUT BALANCED
MAIN VOLTAGE/CONSUMPTION
DIMENSIONS
WEIGHT (with envelope)

SPECIFICATIONS

1 Hz - 20 kHz ±0.25 dB
117dB
1.8 V RMS at 1 kHz, 0 dB
> -97dB
100 hm min load 1 K hm
1 pair per channel (RCA)
1 pair per channel (XLR)
230/120/100V 50/60Hz 25W
17 in (W) x 13.8 in (D) x 3.4 in (H)
43.3 cm (W) x 35 cm (D) x 8.7 cm (H)
26,5 lbs. (12,0 Kg)