Rear Panel - North Star SAPPHIRE Operating Manual

6 REMOTE SENSOR RECEIVER
7 OPERATE LED INDICATOR
The Operate LED show the operating mode of your CD Player:
Glows blue when the CD Player is in Operation mode.
Off the CD Player is in Stand-by.
8 STAND-BY LED INDICATOR
The Stand-by LED show the operating mode of your CD Player:
Glows red when the CD Player is in Stand-by.
Off the CD Player is ready to use.
If the CD Player will not turn on, you may want to check the rear panel AC
mains switch , your AC connections, or have your dealer inspect the rear panel fuses.
9 CD TRAY
10 OPEN/CLOSE PUSHBUTTON
11 PLAY PUSHBUTTON
12 STOP PUSHBUTTON
13 PAUSE PUSHBUTTON
Caution!
Switch Off the SAPPHIRE CD PLAYER when you need to connect or disconnect any cables.
14 AC MAINS SWITCH
This switch may be used to disconnect the power supply from the AC mains without having to
actually unplug the CD Player from the wall outlet. If you plan to be away for an extended period, or
have any other reason to turn the CD Player completely off, you may use the AC mains switch.
15 AC MAINS FUSES
Two slow-blow 315mA (220-240V), 630mA (100-120V) fuses are located inside a small drawer in
the AC main inlet. If you suspect that your AC fuse have blown, disconnect the CD Player from the
AC mains and contact your North Star Design dealer for assistance.
16 AC MAINS INLET
Standard IEC power cords is provided with the SAPPHIRE CD Player. High quality power cords
will improve the sonic performances; ask your North Star Design dealer.
The North Star Design SAPPHIRE CD Player has been safety-tested and is designed for
operation with a three-conductor power cord. Do not defeat the "third pin" or earth ground
of the AC power cord.
17 UNBALANCED ANALOGUE OUTPUT
Use this output to connect the CD Player to the input of a preamplifier or integrated amplifier using
interconnect provided with RCA connectors (not shipped with the equipment).

Rear Panel