Dell OptiPlex 740 User Manual page 119

4. Align the shoulder screws on the optical drive with the shoulder screw slots, and slide the drive into the bay until it clicks into place.
1 optical drive 2 shoulder screws (3)
5. Connect the power and optical drive cables to the drive.
6. Connect the drive cable to SATA2 or SATA3 on the system board (see
1 power cable 2 optical drive cable
See the documentation that accompanied the drive and controller card to verify that the configuration is correct for your computer. Change any settings
necessary for correct configuration.
7. Check all cable connections, and fold cables out of the way to provide airflow for the fan and cooling vents.
8. Install the drive panel to the front of the computer. The drive panel only fits one way (see
9. Replace the computer cover (see
10. Update your configuration information in system setup (see
11. Verify that your computer works correctly by running the Dell Diagnostics (see
2
1
3
3 shoulder screw slots (2)
3 optical drive connector (SATA)
Replacing the Computer Cover).
System
System Board Components for mini tower computers).
Drive-Panel
Setup) by setting the appropriate Drive option (0 or 1) under Drives.
Dell Diagnostics).
Inserts).