Advertisement
Operation of High Speed Floor Machine
* READ OPERATORS MANUAL
THOROUGHLY PRIOR TO OPERATING OR
SERVICING THIS MACHINE.
GENERAL USE
1. Remove any obstructions or other
obstacles in the area which is to be
cleaned.
2. Place the handle in the upright
position and tilt machine back until
handle rests on the floor
* Be sure the machine is not plugged
into an outlet
3. Attach the pad to the machine by first
unscrewing the male end of the "big
mouth" from the flexible pad driver.
Place the approved pad on the pad
driver, place the male end of the "big
mouth" into the center hole of the
pad, and tighten the "big mouth"
firmly to the pad driver.
4. Place machine back into its upright
position.
5. Plug power cord into a grounded
outlet.
* Never use an extension cord in
conjunction with the standard power cord.
6. The handle height may be adjusted by
lifting up the compression handle
which is located on the right side of
the handle tube about 1 foot above
floor level. Release the compression
handle and adjust handle to safe
operating height, then push back
down on the compression handle to
lock the handle in operating position.
7. To start the machine, press the red
safety button on the top of the upper
switch housing, and then squeeze
either of the operating triggers. (the
safety button must be depressed
prior to squeezing the operating
triggers.)
8. When the machine is in operation,
both hands should be placed on the
switch housing (upper handle).
9. To stop the machine at any time,
simply release the operating trigger(s)
and the machine will stop
automatically.
MAINTENANCE
To keep the machine performing well for
many years, please follow the following
maintenance procedures.
* Always confirm that the machine is
unplugged prior to performing any
maintenance or repairs.
1. Unplug machine as soon as you are
done using it.
2. Clean the outside of the machine with
a mild cleaner.
3. Check power cord for any damage. If
damage is detected, replace power
cord immediately.
4. Lubricate wheels with a water
resistant lubricant once a month.
5. Check machine for loose or missing
nuts and bolts, and replace as
necessary.
6. If the machine is used in a dusty
environment, you may remove the
motor cover and blow the motor clean
with compressed air. This will ensure
proper ventilation, and allow the
motor to run cooler.
STORAGE
1. Unplug machine from power source
and wrap cord on handle.
2. Tilt machine so the pad is not
touching the floor.
3. Store machine in upright position and
in a dry area.
5
Hide quick links:
Advertisement
