Machine Operation (Scrubbing And Drying); Adjusting The Level Of Orbital Deck (Only For Orbital Machine) - Viper AS6690T-US Instructions For Use Manual

INSTRUCTION FOR USE
NOTE
To move the machine forward, press either the left or
right safety switch (F, Figure 13) or both.
Stopping the machine
Stop the machine by releasing the safety switches (F, Figure 13)
1.
The brushes stops. The vacuum system stops after a few seconds.
2.
Lift the brush/pad-holder deck (K) by pressing the one button start (L).
3.
Lift the squeegee (I) with the Squeegee lifting/lowering handle (J).
4.
Turn the ignition key (A) to "0".
5.
Make sure that the machine cannot move independently.
6.

MACHINE OPERATION (SCRUBBING AND DRYING)

Start the machine as shown in previous paragraphs.
1.
While pressing either safety switch (35, Figure 2), maneuver the
2.
machine and start scrubbing/drying the floor.
If necessary, stop the machine then adjust squeegee according to
3.
section "Adjusting balance of squeegee".
ADJUSTING THE LEVEL OF ORBITAL DECK (ONLY FOR
ORBITAL MACHINE)
Insert the ignition key (42) and turn it to "I".
1.
Lower the brush/pad-holder deck (25) by pressing the one button start
2.
(48)
Adjust the level of orbital deck by adjusting handle (A, Figure 14) so
3.
that the bubble is in the center (B Figure 14).
A
O
M
I
K
19
ENGLISH
C
1S
F
G G
F
Figure 13
Figure 14
H
L
N
E
J