Hotpoint DSC60G Instructions For Installation And Use Manual page 21

Care and Cleaning
Wall-mounted splashpanel:
A wall-mounted splashpanel is available as an
optional extra from the Spare Parts Department. See
back cover for details.
Care must be taken that rating label edges are not
lifted during cleaning and furthermore that the
lettering is not blurred or removed.
For details of your nearest Service Centre please see
the separate service leaflet. If you have any queries
regarding service or spares, our Spares and Service
Division will be pleased to advise.
See back cover for details.
Glass Inner Door with three Panels Glass Inner Door with three Panels Glass Inner Door with three Panels Glass Inner Door with three Panels Glass Inner Door with three Panels
(HUE61; HUE63P) (HUE61; HUE63P) (HUE61; HUE63P) (HUE61; HUE63P) (HUE61; HUE63P)
The glass panel may now be washed at the sink.
Stubborn stains can be removed by using a fine
steel wool soap pad. Ensure the glass panel is
not subjected to any sharp mechanical not subjected to any sharp mechanical
not subjected to any sharp mechanical not subjected to any sharp mechanical not subjected to any sharp mechanical
blows. blows. Take particular care not to damage the inner blows.
blows. blows.
surface which is coated with a heat reflective layer.
After cleaning, rinse and dry with a soft cloth. For
slight soiling the inner glass panel may be cleaned,
while still warm, without removing it from the door.
Warning: Oven must not be operated with inner door
glass removed.
SIDE OPENING DOORS
Cleaning the door glass is the same as the drop
down doors, except take care to support the weight
of the inner glass when removing and refitting.
Take care Take care Take care Take care during cleaning not to damage or distort Take care
the door seals. Do not lift the door seal from the
oven chassis, if necessary remove the seal by
carefully unhooking the corner clips.
Take care that the rating label edges are not lifted Take care Take care Take care Take care
during cleaning, and furthermore that the lettering is
not blurred or removed.
When refitting the glass make sure it is fitted
correctly i.e. reflective face is fitted the right way
round.
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
Open the door fully
and carefully slide the
inner glass towards
you, taking care not to
allow the glass to fall.
Ensure the glass panel is Ensure the glass panel is
Ensure the glass panel is Ensure the glass panel is
Cleaning the glass doors
SIDE OPENING DOORS
Cleaning the door glass is the same as the drop
down doors.
The glass panels may now be washed at the sink.
Stubborn stains can be removed by using a fine
steel wool soap pad.
Replace in the reverse order.
Ensure anti-rattle bungs are fitted before fitting inner
door glass.
BE CAREFUL NOT TO DAMAGE THE GLASS
PANELS BY PUSHING THEM TOO HARD.
When fitting the glass make sure it is fitted correctly
ie reflective face is fitted the right way round.
Ensure the glass panel is not subjected to any sharp
mechanical blows. Take particular care not to
damage the inner surface which is coated with a heat
reflective layer. After cleaning, rinse and dry with a
soft cloth. For slight soiling the inner glass panel
may be cleaned, while still warm, without removing it
from the door
Warning: Oven must not be operated with inner door
glass removed.
Open the lower door
and lift out the inner
door glass
Remove the two
rubber anti-rattle
bungs
Remove the centre
glass taking care to
support the weight of
the glass when
removing and fitting
21
GB