5. Installation
5.5.2 USB Server Interface Unit
Connecting a NetCommander USB Server Interface Unit (Model # B078-101-USB)
1. Connect the B078-101-USB VGA connector to the computers VGA port
2. Connect the B078-101-USB USB connector to the computers USB port
3. Connect one end of the Cat5e/6 patch cable to the RJ45 port on the B078-101-USB*
4. Connect the other end of the Cat5e/6 patch cable to the desired RJ45 CPU port*
5. Repeat these steps for each additional USB computer/server you are connecting to the KVM
* Cat5e/6 cable should be no longer than 100 ft.
5.6 Connecting the Power Supply
1. Plug in the KVM. Use only the power cord supplied with the unit.
2. Switch ON the computers.
5.7 Resetting the KVM Switch
To reset the KVM switch, press both "Select" buttons on the front panel simultaneously. The Server
Interface Units are unaffected by this reset.
( continued )
Up to 100 ft.
SIU = Server Interface Unit
Figure 5.4.2 NetCommander USB Server Interface Unit
6 6
To VGA port
To USB port