Related Manuals for Ferroli 30800009
Summary of Contents for Ferroli 30800009
- Page 1 Radio Thermostat Clock Part Number: 30800009 Installation & User Instructions Suitable for all Ferroli Combination Boilers...
-
Page 3: Short Description
The Radio Thermostat Clock is a 7 day radio frequency (RF) wireless thermostat/ timer which communicates with a special receiver designed to replace the universal digital timer fitted to most of Ferroli’s combination boilers. The Radio Thermostat Clock is battery powered and can be sited wherever conventional room thermostats would normally be sited. - Page 5 Optima 01 Range Universal Digital Clock Radio Thermostat Clock Receiver Step 1 Remove clock from control panel. Step 2 Swap wiring as shown. Make sure Live is connected to terminal 1 (wire colour is not conclusive of polarity) Step 3 Fit receiver into control panel. Note.
- Page 6 Domina, Modena and Falcon Note. If the Radio thermostat clock is going to replace the existing room thermostat this must be linked out on the room thermostat terminal block. Universal Digital Clock Radio Thermostat Clock Receiver Step 1 Remove clock from control panel. Step 2 Swap wiring as shown.
- Page 7 Optimax 25C Note. If the Radio thermostat clock is going to replace the existing room thermostat this must be linked out on the room thermostat terminal block. Universal Digital Clock Radio Thermostat Clock Receiver Step 1 Remove clock from control panel. Step 2 Swap wiring as shown.
- Page 8 Optimax HE Range Step 1 Remove boiler outer case and lower control box. Step 2 Remove control box cover. Step 3 Connect brown and blue JST plug onto PCB terminal block X2. Step 4 Connect brown and blue onto receiver terminals 1 and 2. Make sure live is connected to terminal 1.
-
Page 9: Installation
Installation ATTENTION! Radio link installation 1. Install transmitter and select continuous radio operation system mode. (See page 17) 2. Press receiver button and hold down for 2 seconds. The LED flashes twice. Then release the button. The LED remains on between 1 and 10 seconds. When a correct link between the transmitter and receiver has been established the LED goes off.