Page 1
Contact Details Please note that some of the contact details on this PDF document may not be current. Please use the following details if you need to contact us: Telephone: 0844 879 3588 Email: customer.services@gdcgroup.co.uk The Help Centre section of this website also features a wide range of information which may be of use to you and is available 24 hours a day. It includes: • Operating and installation instructions downloads • Request a repair • Where to buy our products • Literature downloads • Heating requirement calculator www.credaheating.co.uk/help‐centre A division of GDC Group Ltd Registered No: 1313016 England VAT GB 287 1315 50004 Millbrook House Grange Drive Hedge End Southampton SO30 2DF EEE Producer Registration Number –...
The BLACK control wire is designed to carry a signal from the heater. slot in or wall mounted Creda programmers. If, however a WARNING – THE SURFACES OF THIS HEATER CAN BE HOT. programmer is not being used, the pilot wire should be...
General Turn on the heater using the ‘ ’ button and rotate the thermostat knob to the desired position. When the room The TPR III E Electronic panel heater is designed for wall temperature has reached the desired level, the power to the mounting on the wall brackets supplied.
Notes to the Installer Lift the cover away from the heater (see Fig. 6) to reveal the slide in compartment. Test Mode When the TPR III E Panel Heater is connected via a pilot wire system, the test mode allows the installer to check whether the heater is responding correctly to the incoming pilot wire signal.
Please retain your receipt as proof of purchase. The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility (EMC) EN55014, EN60555-2, EN60555-3. These cover the essential requirements of EEC Directives 2006/95/EC and 2004/108/EC. CREDA HEATING MILLBROOK HOUSE TEL: 0845 604 2399...