1. On the Advanced Menu, click Network Monitor Display Settings..
Figure 6-11
2. Click the Turn Off LED button. (This setting is also a toggle. Clicking it again turns back on
the LED.)
3. Click Apply.
Setting the Dome LED Display
You can set the blue Dome LEDs to monitor and display the following statuses:
•
Wireless data status – This is the default setting. The LEDs blink when wireless data is being
transmitted. The left LED shows incoming data and the right LED shows outgoing data.
•
Guest Network status – The LEDs are both on when Guest Network is enabled, and blink
when a computer is connected to the Guest Network.
•
Live Parental Controls status – The LEDs are both on when Live Parental Controls is
enabled, a blink when an attempted access is blocked.
•
Broadband Usage Meter status – The LEDs blink when usage reaches the warning level and
remain on when the usage reaches the pre-set limit.
Click Apply to save your display settings.
Using Network Monitoring Tools
RangeMax Wireless-N 150 Router WPN824N User Manual
v1.0, February 2010
6-14