Before Using (Charging The Headset); Set Up And Configuration; Set Up For Driver-To-Passenger Intercon: Pairing - Cardo Systems SCALA RIDER TEAMSET PRO User Manual

1 Dual Wall Charger
2 Allen Wrenches
2 sets of Velcro Pads
2 MP3 Cables
2 MP3 Cable Holders
2 Glue Plates
2 Pre-moistened Towelettes
2 Carry-Pouches
4 Microphone Sponges
Flat sponge for full-face helmets and round sponge for other helmet types
User Guide, including Warranty and Registration form
The cover tongue protecting the Charging Jack should be kept tightly
closed at all times to prevent moisture from entering the device.
NOTE: WHILE MOST INSTRUCTIONS IN THIS MANUAL REFER TO THE HEADSET IN THE
SINGULAR, THEY APPLY TO BOTH UNITS UNLESS INDICATED OTHERWISE.
BEFORE USING (CHARGING THE
HEADSET)
Make sure that the headset is fully charged for at least four hours
before initial use.
1. Connect the wall charger to the headset's Charging Jack (located
between the two Volume Buttons).
2. While charging, the Red Light turns on (it may take up to 15
seconds until the Red Light turns on). When charging is complete,
the Red Light will turn off.
4 scala rider ® TeamSet ™
PRO
IMPORTANT:

SET UP AND CONFIGURATION

Mobile
phone
Driver-to-
Passenger
Full-duplex
Intercom
Connection
SET UP FOR DRIVER-TO-PASSENGER INTERCOM:
PAIRING
Pairing is a one time process that is required for mutual recognition
between a headset and other Bluetooth devices. Once the two head-
sets are paired, they will remain paired and automatically recognize
each other whenever they are within range. The two headsets in
your retail box are already factory paired and relate to each other as
the Buddy connection. If for any reason, you have to pair them again,
proceed as follows:
1. If either headset is turned OFF, turn it ON by pressing and holding
the CTRL Button until the Blue Light flashes three times.
2. Make sure that both headsets are now flashing slowly in Blue.
GPS
MP3
player