Setup
Preparation
1. Connect air and material hoses to gun. Tighten
securely.
2. Connect one end of material hose (cc) to material
outlet (K or L) and other end to gun material inlet
(bb).
NOTE: Material plug must be installed in material
outlet (K or L) you are not using.
L
N
3. Open gun air valve (23).
313384B
23
ti4003a
K
cc
dd
Removing and Installing Hopper
Hopper (G) can be removed from cart for cleaning and
when using Siphon Kit 248112 (available from Graco
distributor).
Removing Hopper (G)
1. Push down 2 latches on each side of hopper cou-
pler (H).
2. Lift hopper (G) straight up off of unit.
Setup
7