Fishman PREFIX PRO BLEND User Manual page 5

Hide thumbs Also See for PREFIX PRO BLEND:

Power

Plug in the guitar, and the Preﬁ x Pro Blend switches on. The Battery LED will ﬂ ash

once at power-up to tell you the preamp is on.

Low battery indicator

When the Battery indicator lights steadily, it is time to change the battery. To

conserve power, unplug the instrument when not in use. Replace the battery by

ﬂ ipping open the preamp body using the latch located at the top of the preamp.

Be sure to observe the correct polarity during this installation.

Microphone Trim Adjustment

The microphone and pickup levels are preset at the factory and do not require

adjustment. However, a microphone trim control may be adjusted to alter the

microphone and pickup balance.

Set the Blend slider to the center position and ﬂ ip open the preamp body. The

trim control is located under the control panel next to the Bass slider. Use a small

screwdriver to adjust the trim control as necessary.

Table of Contents