Cambridge SoundWorks Newton P1000 User Manual page 11

jack in the Control Module.
To insure you connect the wires properly (positive to
positive, negative to negative), note which of each
speaker wire's two conductors is "marked". This mark-
ing may be a ridge in the insulation, different colored
conductors or printing on only one side. Use the
marked side of the speaker wire to connect the posi-
tive speaker terminals. Use the other wire for the nega-
tive terminals.
Using a small flat bladed screwdriver, loosen the four
set screws inside the Speaker Wire Connector plug.
Pull out the short speaker wires.
Following the markings on the Speaker Wire Connector
diagram (for Right positive, Right negative and so on),
insert the correct wires into the plug's openings.
SUB IN
LEF T
S
HIG H PAS
RIG HT OU T
HIG H PAS S
OU T
LEF T IN
IN
CEN TER
RIG HT IN UTS
LEV EL INP
PRE AM P
E
L MO DUL
CON TRO INS IDE
LE PAR TS
SER VIC EAB NEL
PER SON
NO USE R QUA LIFI ED
VIC ING TO
REF ER SER
12V
AC INP UT
s US A JAC KS
ssa chu sett INT ERF ACE
New ton , Ma ON
na
Ma de in Chi
–
+ AUT O
–
+
–
+
OFF
2
1
LEF T
CEN TER
RIG HT UTS
LEV EL INP
SPE AKE R
Tighten each set screw to hold the wires in place.
Connect to the Subwoofer Enclosure: Once the
input connections are made to the Control Module,
connect the Interface Cable from the Control Module
to the Subwoofer Enclosure.
The interface Cable has plugs that look and connect
like telephone connector plugs. The plugs are the
same at both ends.
Making sure both the Control Module and
subwoofer enclosure are disconnected
from any AC power source.
Note: The second Interface Cable jack on the sub-
woofer enclosure allows you to connect a Newton
Series second subwoofer enclosure with a sub to sub
Po we red
Su bw oo fer PO WE R
000 000 00
INT ER FA
CE JA CK
11 11 11
12 0V AC
7.0 A
S