Electrical Connections; General Description - Jet BDB-1340A Owner's Manual

Electrical Connections

WARNING
All electrical connections must be completed
by a qualified electrician!
Failure to comply may cause serious injury
and / or damage to the machinery and
property!
The BDB-1340A bench lathe is rated at 2HP,
1Ph, 230V only. Confirm power available at the
lathe's location is the same rating as the lathe.
Make sure the lathe is properly grounded.

General Description

Lathe Bed
The lathe bed (A, Fig. 9) is made of high grade
cast iron. By combining high cheeks with strong
cross ribs, a bed with low vibration and high
rigidity is realized. Two precision ground vee
slideways, reinforced by heat hardening and
grinding, are an accurate guide for the carriage
and headstock. The main drive motor is
mounted to the rear of the bed.
Carriage
The carriage (B, Fig. 9) is made from high
quality cast iron. The sliding parts are smooth
ground. The cross-slide is mounted on the
carriage and moves on a dove-tailed slide which
can be adjusted for play by means of the gibs.
The compound slide (C, Fig. 9), which is
mounted on the cross slide (D, Fig. 9), can be
rotated through 360°. The compound slide and
the cross slide travel in a dovetail slide and have
adjustable gibs. A four-way tool post (E, Fig. 9)
is fitted on the compound slide.
Headstock
The headstock (F, Fig. 9) is cast from high
grade, low vibration cast iron. It is mounted to
the bed by four bolts with two adjusting bolts for
alignment. In the head, the spindle is mounted
on two precision taper roller bearings. The
hollow spindle has Morse Taper #5 with a 1-1/2"
bore.
Four Way Tool Post
The four-way tool (E, Fig. 9) post is mounted on
the compound slide and allows a maximum of
four tools to be mounted simultaneously.
Remember to use a minimum of two clamping
screws when installing a cutting tool.
11