Toyota Solara Operating Manual page 141

NOTICE
Canada only:
As your hand held garage door open-
er may automatically stop sending the
signal during programming, press and
re- press the hand held garage door
opener button every two seconds dur-
ing steps 1 through 4 above until the
frequency and code is registered.
If you want to replace an existing program
with a new program, select the button
you want to program. Follow the proce-
dure from step 1.
If the transmitter has a rolling code
feature, it is necessary to program the
in- garage receiver after programming
HomeLink_.
1. Locate the training or learning but-
ton on the in- garage receiver and
push and release this button. Loca-
tion of the button may vary among
garage door opener manufacturers.
SOLARA_U
2. Firmly push and release the trained
HomeLink_ button 2 times (some ga-
rage door manufacturers may require
you to push the HomeLink_ button
up to 3 times) to complete the pro-
cess.
The garage door should now operate
when the HomeLink_ button is pushed.
Do not use the HomeLink_ universal
transmitter with any garage door opener
that lacks the safety stop and reverse
feature as required by Federal Safety
Standards. This includes any garage door
opener model manufactured before April 1,
1982.
CAUTION
When programming or operating the
garage door opener, make sure there
is no one around the moving door.
(b) Operating the garage door opener
Push the appropriate button to activate the
garage door opener. The indicator light
comes on. The garage door opener contin-
ues to send the signal as long as the
button is pushed (up to 20 seconds).
(c) Erasing the garage door
memory
Push and hold down the 2 outside buttons
for about 20 seconds until the indicator
light flashes. All memorized data will be
erased.
FCC ID: CB2V94800
CANADA: 1763 102 264
This device complies with FCC Part 15.
Operation is subject to the following two
conditions: (1) This device may not
cause harmful interference, and (2) this
device must accept any interference that
may be received, including interference
that may cause undesired operation.
WARNING: This transmitter has been
tested and complies with FCC and
DOC/MDC rules. Changes or modifica-
tions not expressly approved by the
partly responsible for compliance
could void the user's authority to op-
erate the device.
opener
141