Toyota Sienna 2003 Operating Manual page 23

CAUTION
When the vehicle is stopped on a
downward slope of a steep grade
(17% or more), the sliding door may
not stay in the fully–opened position
and could suddenly close by itself,
possibly resulting a personal injury.
Making sure the sliding door does not
close abruptly, turn on the power
sliding door system. Then the sliding
door will operate under the control of
the electric power.
03 SIENNA_U (L/O 0207)
RESETTING THE POWER SLIDING
DOOR SYSTEM
If the power sliding door system operates
incorrectly or does not operate under the
following conditions, the system must be
initialized and reset by the steps in the
next column.
D
The battery is disconnected and then
reconnected, or a discharged battery is
recharged.
In this case, initialize and reset the
system by doing the following steps
from 6 to 10.
D
The open power sliding door warning
light stays on though the sliding door
is closed.
In this case, initialize and reset the
system by doing the following steps
from 1 to 10.
CAUTION
To initialize and reset power sliding
door system, stop the vehicle on a
level ground.
2003 MY SIENNA (OM45410U)
1. Be sure to turn off the power sliding
door system by pushing in the "PWR
DOOR OFF" switch.
2. Disconnect the battery for 1 minute
and then reconnect it.
3. Close the sliding door by hand.
(Step 3 can be performed before step
2.)
4. Turn on the power sliding door system
by pushing out the "PWR DOOR OFF"
switch.
5. Wait 5 seconds.
6. Open the sliding door by using one of
the "DOOR L", "DOOR R" and "PWR
DOOR" switches.
7. Wait 3 seconds after the sliding door
stops at the fully–opened position.
8. Close the sliding door by using one of
the "DOOR L", "DOOR R" and "PWR
DOOR" switches inside the vehicle or
"POWER DOOR", "D–PWR DOOR" and
"P–PWR DOOR" switches of the wire-
less remote control transmitter.
9. Wait 3 seconds after the sliding door
stops at the fully–closed position.
10. Repeat the steps from 6 to 9.
23