Toyota Sienna 2003 Operating Manual page 213

Remove spacers from the center panel.
Place the largest spacer on the pin that
would be below transmitter button when
the cover is closed. Close the cover.
03 SIENNA_U (L/O 0207)
When the garage door opener transmitter
is properly installed, you can operate the
transmitter by pushing the center panel of
the cover.
2003 MY SIENNA (OM45410U)
If the center panel does not contact your
garage door opener transmitter:
_
Check to see if spacer is on the cor-
rect pin.
_
Attach another spacer to the top of
original spacer. Check operation. If re-
quired, continue to add spacers until
contact is achieved.
If the transmitter is clattering during driv-
ing, fill in a piece of felt or pad to prevent
the transmitter from clattering.
213