Toyota Celica 2001 Operating Manual page 104

CONTROL / MODE (Audio control and
mode adjustment)
Manual tone adjustment function—
This knob is used to adjust the tone
manually.
For low–pitch tone adjustment,
"CONTROL / MODE" repeatedly
"BAS" appears on the display. Then turn
the knob to suit your preference.
The display will show the range from
"BAS –5" to "BAS 5".
Vehicles with 8 speakers only—for middle–
pitch tone adjustment, push "CONTROL /
MODE" repeatedly until "MId" appears on
the display. Then turn the knob to suit
your preference.
The display will show the range from "MId
–5" to "MId 5".
For high–pitch tone adjustment,
"CONTROL / MODE" repeatedly
"TRE" appears on the display. Then turn
the knob to suit your preference.
The display will show the range from
"TRE –5" to "TRE 5".
Sound balance adjustment function—
This knob is also used to adjust the
sound balance between the front and rear,
and the right and left speakers.
104
'01MY CELICA U (L/O 0008)
For front/rear adjustment, push "CONTROL
/ MODE" repeatedly until "FAd" appears
on the display. Then turn the knob to
adjust the front/rear balance.
The display will show the range from
"FAd–F7" to "FAd–R7".
push
For left/right adjustment, push "CONTROL
until
/ MODE" repeatedly until "BAL" appears
on the display. Then turn the knob to
adjust the left/right balance.
The display will show the range from
"BAL–L7" to "BAL–R7".
CD (Compact Disc)
Push "CD" to switch from radio or cas-
sette operation to compact disc operation.
If the audio system is off, you can turn
on the compact disc player by pushing
"CD". In both cases, a disc must already
be loaded in the player.
push
When the audio is set into compact disc
until
operation, the display shows the track or,
track and disc number currently being
played. Each time you push "CD", the
system changes to the automatic changer.
If the player malfunctions, your audio sys-
tem will display one of the six following
error messages.
2001 CELICA (20766U)
If "WAIT" appears on the display, it indi-
cates that the inside of the player unit
may be too hot due to the very high ambi-
ent temperature. Remove the disc or mag-
azine from the player and allow the player
to cool down.
If "Err 1" appears on the display, it
indicates the disc is dirty, damaged, or it
was inserted up–side down. Clean the
disc or insert it correctly.
If "Err 2" appears on the display, it
indicates no disc is loaded inside the
magazine. Insert a disc.
If "Err 3" or "Err 4" appears on the
display, it indicates there is a trouble in-
side the system. Eject the disc or maga-
zine. Set the disc or magazine again.
If "OPEn" appears on the display, it
indicates the compact disc auto changer
lid is open. Close the compact disc auto
changer lid.
If the malfunction is not rectified, take
your vehicle to your Toyota dealer.