Display Backlighting; Basic Operation; Set Mode - Icom IC-440N Instruction Manual

■

Display backlighting

The transceiver has a backlight display for night-time and
low-light operation. Select the desired mode.
F
q
Hold down (Set Mode) for 2 sec. to enter Set mode.
SET
w
F MONI
Push * or * several times until "LIGHT" appears.
T SQL
SET
e Push
or to select the display backlight option.
• ON : Backlight lights continuously.
• A2 : Lights for 5 seconds when any key except [PTT] is
pushed, or the LCD display is changed.
• At : Lights for 5 seconds when any key except [PTT] is
pushed or the Selcall signal is transmitted or received.
• OF : No Backlight.
r Hold down
for 2 seconds to turn OFF the power, or
F
hold down (Set Mode) for 2 seconds to exit the Set
SET
mode.
*Regardless of the assigned key function.
■

Set mode

All Set mode items are selectable at power ON and allow
you to set seldom-changed settings. You can "customize" the
transceiver operation to suit your preferences and operating
style. See page 20 for Set mode item details.
Entering the Set mode:
q
While holding down
seconds to turn ON the power. Then, hold down
Mode) for 2 seconds to enter the Set mode.
w
F
Push * or MONI * several times to select the appropriate
SET T SQL
items.
Then push or to set the desired level/condition.
• Available Set mode items are SQL Level, CTCSS tone/
DTCS code, Auto Power OFF, Backlight, Brightness,
Contrast, Beep, Beep Level, Mic Gain, Signal Message,
Lock-Out, Scan Stop Timer, Scan Restart, Roger Beep, PTT
Hold, Speaker and Own ID.
e
Hold down for 2 seconds to turn OFF the power, or hold
down F (Set Mode) for 2 seconds to exit Set mode.
SET
NOTE: The Set mode can be accessed by pushing
(Set Mode) key only (p. 20). In this case, the Set mode
allows quicker item selection. Only the default "Enable"
items are selectable when Set mode is activated. The CS-
440N
CLONING SOFTWARE
*Regardless of the assigned key function.

BASIC OPERATION

and , hold down for 2
F (Set
SET
allows these to be modifi ed.
3
3
F
SET
19