Effects Loop; Power Switch; Specifications - YORKVILLE 100KW Power Wedge Owner's Manual

EFFECTS LOOP

The EFFECTS LOOP can be used to insert signals from external sources such as a Digital
Effects or Equalizers into the signal path. The loop is inserted after the tone and volume
controls. To use the EFFECTS LOOP connect the EFX SEND jack to the input of the
equalizer or effects unit. Connect the output of the equalizer or effects unit to the EFX
RTN jack to complete the loop.
LINKING TOGETHER MULTIPLE WEDGES
When the Yorkville 100kw Power Wedge is used with a line level input for stage moni-
tor purposes, it's possible to link together several units by using the inputs on Channel 2.
Insert the mixed signal from a mixing console into either of the two phone jacks (on
Channel 2). It is possible to use the remaining phone jack input on Channel 2 as an out-
put to link to another Yorkville 100kw.
PHONES
Headphones can be connected to the Yorkville 100kw by inserting a headphone plug
into the PHONES jack located on the front panel. While headphones are connected, the
internal speaker is disconnected. Always use stereo headphones. The audio heard
through stereo headphones will be a mono signal separated into the two earpieces.

POWER SWITCH

When the Yorkville 100kw Power Wedge is turned on, the LED beside the power switch
will be illuminated.
2
Please note: that only information being sent to the input of Channel 2 will be linked.
Caution: Always exercise caution when using headphones to avoid permanent hearing loss.
Channel 1 Input one XLR jack
Channel 2 Input two phone jack
Effects Send phone jack
Effects Return phone jack
Speaker Components Woofer 12", 4-Ohm, 100 Watt
Power Rating >115W, 4-Ohm load, 1 KHz, 2 cycle burst
Construction 1/2" Poplar Plywood with internal bracing
Exterior Finish Black carpet
Dimensions 23.5"x22.25"x14.5" (HWD)
Power Requirements 120V AC 60Hz 0.3A

SPECIFICATIONS

Jack Config Sensitivity
3 mVrms
one phone jack 10 mVrms
75 mVrms
two RCA jacks 150 mVrms
1 Vrms
1 Vrms
Tweeter RCF N252P driver, 8-Ohm, 30 Watt
>100W, 4-Ohm load, 1 KHz, continuous at 5% THD
* Measurements made with regulated power supply
60cm x 56.5cm x 37cm (HWD)
230V AC 50Hz 0.15A