Connections; Connecting Other Components; Wired Remote Control - Harman Kardon HK670 Owner's Manual

Connections

Speaker System 1 Record Player
Right channel
Right channel
Speaker System 2

Connecting Other Components

1. Make sure your amplifier and other compo-
nents are turned off.
2. Connect each component's Output/Play jacks
to the corresponding Input jacks on the back
of your amplifier and, if available, the compo-
nent's Input/Record jacks to the Output jacks
of the HK670. Use the white, black or gray
plugs to connect Left channel jacks; use the
red plugs for Right channel jacks.
3. A record player with MM cartridge must be
connected to the Phono Input jacks and a
separate ground wire to the ground terminal
screw above.

Wired Remote Control

To control your amplifier with an external
infrared remote sensor, connect the wire from
the remote sensor to the REMOTE IN jack on the
back panel. Or, if another stereo component has
a built-in infrared remote sensor and a Remote
Output jack, it may be possible to connect this
jack to the REMOTE IN jack of your amplifier. All
Harman Kardon products with »Remote In« and
»Remote Out« jacks are compatible with one
another, except for the Citation 22, 24 and 25.
Other manufacturers' remote sensors and com-
ponents may not be compatible, but it will not
hurt to experiment. A second wire may be used
to connect your amplifier's REMOTE OUT jack to
the Remote Input of another stereo component.
CONNECTIONS
4
Cassette Tape Deck
Video Player 2 Video Player 1
Continue this process to include additional com-
ponents (if compatible).
Connecting Speakers
1. For best performance, use high quality speak-
er cables. However, ordinary copper wire can
be used if the gauge meets the following
requirements:
Wire
Length
Up to 2.5 meter
Up to 4 meter
Up to 6 meter
Above 6 meter
2. Avoid rolling excess wire with or near signal
interconnects.
CD Recorder
Compact Disc Player
Tuner
IMPORTANT: When connecting two pairs of
speakers, determine the impedance of each pair
by looking on the back of the speakers, in your
owner's manual, or by contacting your dealer or
manufacturer.
You can listen to two pairs of speakers at
the same time ONLY if the impedance of
EACH speaker is NOT LESS THAN 8 Ohms.
Min.
Diameter
WARNING: Do not play sets of speakers simul-
1 mm
taneously except as recommended above. Ampli-
1.25 mm
fier may overheat.
1.6 mm
2-2.5 mm Digital Loop-Through
Digital inputs and outputs are provided only as a
convenience for connecting various digital com-
ponents to the "CD", "CDR" and "AUX" digital
inputs. The corresponding digital input signal is
fed to the "DIGITAL OUT" connector when
"CD", "CDR" or "AUX" is selected as input
source, to provide a digital signal for CD or MD
Recorders. The HK670 cannot process, decode or
convert any digital signal.
AC Power
Plug the cord into a 230 VAC wall socket.
Speaker System 1
Left channel
Left channel
Speaker System 2