Introduction Congratulations on your choice of the General instructions Moving the Unit Harman Kardon HK670 Integrated Amplifier. Before moving the unit, be sure to pull out the Always Use at 230V AC power cord from the AC outlet and disconnect...
You can listen to two pairs of speakers at nent’s Input/Record jacks to the Output jacks requirements: the same time ONLY if the impedance of of the HK670. Use the white, black or gray EACH speaker is NOT LESS THAN 8 Ohms. Wire Min.
Controls and Functions HK 670 Power switches Headphone Jack Bass Control Press the round Power button (above “Power”) Plug in headphones if desired. With both Turn to increase or decrease the amount of low to turn the amplifier on for the first time. The “Speaker 1”...
Independent Remote Control Important Notes: Operating Conditions The system remote of the HK670 can control the • For controlling a tuner (only needed for the The control unit operates effectively within a dis- amplifier and compatible Tuners, CD Players and numeric buttons), CD Recorder or CD Player tance of 7 meters and an angle of 30°...
Operating Instructions Listening to your CD player, tape 4. Begin playing the desired source. Making a recording deck, tuner or other source 5. Adjust the Volume control to the desired level. You may record any source to tape or to CD-R or 1.
This unit is designed for trouble-free operation; most problems users encounter are due to operating errors. So if you have a problem, first check this list for a possible solution. If the problem persists, consult your authorized Harman Kardon service center.