Advertisement
3. Set your desired chase pattern. Once you have selected the chase
function use the MODE button to select your desired chase. The
chase pattern is represented in the LCD display by "P" followed
by two numbers. You may select any of the built in 16 programs to
run at a single time.
4. Set your desired chase speed: At this point you may change the
program chase speed. While in chase mode, tap on the MODE
button until the "SP" followed by two numbers is displayed in the
LCD. Then use the UP and DOWN buttons to adjust the chase
speed. A value of 99 will give you the fastest chase speed (about
1/10th of a second). A value of 01 will give you the slowest chase
speed (about one step every 30 seconds)
DMX Mode: Use this operating mode only if you plan to use your
power pack as a DMX switching device. This function will allow you to
turn on non-DMX units on and off with the use of a DMX controller. Only
on and off functions can be performed through this pack. You can set
your power pack to functions as a 1, 2, or 4 channel DMX pack, which
means you can combine the output functions.
1. Plug in a DMX controller to your power pack via the 3-pin XLR
connections on the bottom of the unit.
2. Connect your lighting effects to any of the eight power sockets on
the front of the pack.
3. Decide if you are going to use your power pack as 1, 2, or 4
channels. This function allows you to;
a. Control the output to all four outlets with one DMX channel.
b. Group outlet channels one and two and group outlets channels
three and four. The first group will be controlled by one DMX
channel and the second group will be controlled by another
DMX channel. This gives the pack a DMX value of two.
c. The default setting is a four channel DMX switcher, each
channel is controlled by one DMX channel.
4. To change the channel function mode be sure you are in DMX
mode. Hold the MODE BUTTON down for five seconds. After
holding the MODE BUTTON down a channel value will appear in
the LCD display. Use the UP and DOWN BUTTONS to change the
channel value.
5. The power pack is also initially set to be activated by DMX address
one. To change this setting be sure you are in DMX mode. Use the
MODE button to select the address settings, this will be indicated
LSC
- www.lightstreamcontrols.com - PP-DMX20L Instruction Manual Page 7
©
®
by an "A" in the first character of the LCD followed by three
numbers. Use the UP and DOWN arrow buttons to select your
desired DMX address. Remember the DMX address tells your
DMX controller what channel to activate the pack's functions.
6. Once you have set the pack's DMX address be sure your
controller's address matches that of the packs'.
Fuse Replacement: To replace the protective fuse, use a flat head
screwdriver to unscrew the fuse holder. Pull out the old fuse and replace
it with a new one. Insert the fuse back into slot and tighten. Always
replace with the exact same type fuse remove unless otherwise speci-
fied by an authorized LSC
service technician.
®
Caution: Always disconnect the units main power before performing
any type of service or fuse replacement!
For any service related issues, please contact LSC
LSC
- www.lightstreamcontrols.com - PP-DMX20L Instruction Manual Page 8
©
®
.
®
Advertisement
