Advertisement
Functions and Controls Front Panel:
CH:01
CH:04
A:001
A:512
P:01
P:16
SP:01
SP :99
1. Down Button - This button will decrease the displayed value in the
LCD display.
2. MODE Button - This button will activate the different functions in
DMX and chase modes.
3. Up Button - This button will increase the displayed value in the
LCD display.
4. LCD Display - This multifunction display will detail all chase and
program activity that pertains to the current operating mode of the
pack.
5. GREEN L.E.D. Indicators - These LEDs will indicate their relevant
channel activity.
6. POWER OUTPUT - 3-prong grounded Edison output sockets. 8
total output sockets. Each channel has an output maxiimum of 6
amps. The unit has an output maximum of 15 amps
LSC
- www.lightstreamcontrols.com - PP-DMX20L Instruction Manual Page 5
©
®
6
5
8888
4
1
2
3
Figure 5
Functions and Controls Rear Panel:
POWER INPUT
F6.3A 250V 5x20 mm
AC 120V ~ 60Hz,
20A MAX
1
2
CAUTION: RISK OF ELECTRICAL SHOCK. DO NOT OPEN
N'OUVREZ PAS..RISQUE DE CHOCELECTRIQUE
WARNING: THIS APPARATUS MUST ME EARTHED.
7
7. Channel Fuses - Each of the four channels is protected by a 6.3A
fuse. These fuses prevent you from overloading and damaging your
pack. Be sure to always replace with the exact same type fuse.
8. Power Switch - This switch controls the units main power.
9. Power Indicator - This LED indicates the unit is active.
10.DMX Input - This connector accepts your DMX input signal.
11.DMX Output - This connector sends your DMX input signal through
to the next DMX device.
Operation Modes:
The PP-DMX20L ™ has two different operating modes. This unit can be
used as a four channel chaser or as a 1, 2, or 4 channel DMX power
pack. Please follow the instructions below to operate the unit in your
desired mode.
Chase Mode:
Use this operating mode only if you are planning on using your PP-
DMX20L ™ as a four channel chaser. This device has 16 built in pro-
grams, you may select any of these programs to run at one time. You
may control the speed at which the programs will chase.
1. Connect your lighting effects to the any of the eight power sockets
on the pack.
2. Use the mode button to select chase mode. Chase mode is
indicated by "PA" followed by numbers 01-16. "PA" is Programmed
Applied. If "A" appears in the LCD display you are in DMX mode,
the "A" stands for address.
LSC
- www.lightstreamcontrols.com - PP-DMX20L Instruction Manual Page 6
©
®
1=Ground
3
3
2=Data-
2
1
1
2
POWER
3=Data+
INDICATOR
3
4
POWER
DMX IN
DMX OUT
8
9
10
11
Advertisement
