Advertisement
Quick Links
PP-DMX20L
4 CHANNEL DMX
POWER PACK
User Instructions
Light Stream Controls
4295 Charter Street
Los Angeles Ca. 90058
www.lightstreamcontrols.com
Introduction:
Thank you for purchasing the PP-DMX20L
from LSC
. To optimize the performance of this product, please read
®
these operating instructions carefully and familiarize yourself with the
basic operations of this unit. The LSC
DMX power pack. This unit has been tested at the factory before being
shipped to you. There is no assembly required.
The LSC
PP-DMX20L™ is controlled via a standard DMX controller
®
such as the LSC
Show Designer,
®
unit allow you to control special effect lighting, that normally could not
be controlled, by a DMX controller. With this revision to our popular PP-
DMX20
™
we have eliminated confusing dipswitches and replaced them
with an easy to use digital switching device that incorporates the use of
an easy to read LCD display.
Customer Support:
LSC
provides a toll free customer support line to provide set up help
®
and answers to any question should you encounter problems during
your set up or initial operation. You may also visit us on the web at
www.lightstreamcontrols.com for any comments or suggestions.
Service Hours are Monday through Friday 10:00 a.m. to 5:00 p.m.
Pacific Standard Time.
Voice:
(800) 322-6337
Fax:
(323) 582-2610
E-mail:
support@lightstreamcontrols.com
Warning!
To prevent or reduce the risk of electrical shock or fire, do not expose
this unit to rain or moisture. Clearing memory often may cause damage
to the memory chip, be careful not to re initialize your unit frequency
often to avoid this risk. Only use the recommended AC/DC power adap-
tor.
Caution!
There are no user serviceable parts inside this unit. Do not attempt any
repairs yourself, doing so will void your manufactures warranty. In the
unlikely event your unit may require service, please contact LSC.
LSC
- www.lightstreamcontrols.com - PP-DMX20L Instruction Manual Page 2
©
®
™
4 channel power pack
PP-DMX20L,
™
is a four channel,
®
™
or the LSC
DMX-Operator.
®
™
This
Advertisement
Summary of Contents for LSC PP-DMX20L
-
Page 1: Customer Support
DMX power pack. This unit has been tested at the factory before being shipped to you. There is no assembly required. PP-DMX20L The LSC PP-DMX20L™ is controlled via a standard DMX controller ® such as the LSC Show Designer, ™... -
Page 2: Product Description
Your cables should be made Product Description: with a male and female XLR connector The PP-DMX20L, ™ is 1, 2, or 4 channel DMX Power Pack. This pack on either end of the cable. Also, remem- Figure 1 can serve as a stand alone chaser or a DMX power pack. -
Page 3: Chase Mode
SP:01 SP :99 Operation Modes: The PP-DMX20L ™ has two different operating modes. This unit can be used as a four channel chaser or as a 1, 2, or 4 channel DMX power Figure 5 pack. Please follow the instructions below to operate the unit in your 1. - Page 4 To change this setting be sure you are in DMX mode. Use the MODE button to select the address settings, this will be indicated - www.lightstreamcontrols.com - PP-DMX20L Instruction Manual Page 7 - www.lightstreamcontrols.com - PP-DMX20L Instruction Manual Page 8 ©...