Radio Reception; Automatic Tuning; Manual Tuning; Last Station Memory - Grundig OCEAN BOY 350 User Manual

Radio reception

• Switch the radio on and off with the
– The frequency and the wave band will
appear on the display.
• Select the desired waveband with the BAND
switch.
• Adjust the volume with the rotary control E VOL..
Aerials
• For FM reception extend the telescopic aerial fully. To
improve the reception you can incline and rotate the aerial.
If the FM signal received is too strong (in the direct vicinity
of the transmitter) you can retract the aerial.
• For MW and LW reception, the set has a built-in aerial, so
the telescopic aerial is not needed. You can direct the aerial
by turning the set itself.
• For short wave reception (SW) extend the telescopic aerial
and position it vertically.
Selecting Distant or Local
• Slide the DIST/LOCAL selector to the LOCAL position to
reduce interference and distortion when listening to strong
FM or SW stations. This causes the signal to be weakened,
thus reducing interference.
RADIO

Automatic tuning

button. • To activate automatic station search (
y
FM
– The search stops as soon as a station is
MHz
– Stations which are received with a weak

Manual tuning

• Briefly press the + or – button to tune in the corresponding
• If you keep the button depressed, you can rapidly scan
– When you release the button,
• If you briefly press one of the + or – buttons, manual tuning

Last Station Memory

• Your unit is provided with the function '
or – until the frequency display begins 'to run'; then release
the button.
found and tuned to.
field strength may be skipped. These can be
tuned to manually.
direction in individual steps.
large frequency ranges.
switched to.
is switched to.
which means that the station that was playing when the set
was switched off will be selected again when the unit is
switched back on.
OB 350 page 15
), press +
AUTO TUNING
MW
kHz
is automatically
AUTO TUNING
',
LAST STATION MEMORY
GB
15