3. Remove the computer cover. See "Removing the computer cover" on page 83.
4. Locate the ExpressCard. See "Locating major FRUs and CRUs (for models with the 20-inch display)" on
page 73 or "Locating major FRUs and CRUs (for models with the 23-inch display)" on page 76.
5. Carefully remove the four screws
off the system board.
Figure 37. Removing the ExpressCard
6. Connect the new ExpressCard to the ExpressCard connector on the system board. Align the screw
holes in the new ExpressCard with the corresponding holes in the system board and then install the
four screws to secure the new ExpressCard to the system board.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 126.
Replacing the heat sink and fan assembly for GPU
Attention:
Do not open your computer or attempt any repair before reading and understanding "Important Safety Information"
on page 1.
This section provides instructions on how to replace the heat sink and fan assembly for GPU.
Note: The heat sink and fan assembly for GPU is available only in models installed with the GPU.
CAUTION:
The heat sink and fan assembly for GPU might be very hot. Turn off the computer and wait three to
five minutes to let the computer cool before removing the computer cover.
108
ThinkCentre Hardware Maintenance Manual
1
that secure the ExpressCard to the system board and then lift it