Configuration Information - Factory Integrated Models; Step 1: Base Configuration - HP ProLiant DL580 Quickspecs

QuickSpecs

Configuration Information - Factory Integrated Models

NOTE: This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are
ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for information on
configurable product offerings and requirements.
NOTE: Factory Integrated Models must start with a CTO Server
NOTE: FIO indicates that this option is only available as a factory installable option.

Step 1: Base Configuration

HP Models
Step 2: Choose Required Options (only one of the following from each list unless otherwise
noted)
HP Processors
HP ProLiant DL580 G7 (E7) Configure-to-order Server
Factory Integrated Models ship with:
HP NC375i Integrated Quad Port Gigabit Server Adapter
Four HP DL580G7/DL980 G7 (E7) Memory Cartridges
Five standard PCI-express slots
HP Smart Array P410i/ Zero Memory Controller
Four redundant hot-plug fans
SFF SAS/SATA/SSD drive cage
HP Integrated Lights-Out 3 (iLO 3) management processor: integrated on system board
Rack (4U), 7-inch
NOTE: Power supplies need to be selected separately from Step 2 below.
NOTE: Customers purchasing the Intel® Xeon® Processor E7 series will need to
purchase the HP DL580R07 (E7) CTO Server (PN 643086-B21)
HP ProLiant DL580 G7 (E7) BC NIC Configure-to-order Server
Factory Integrated Models ship with:
HP Ethernet 1Gb 4-port 331i Integrated Server Adapter
Four HP DL580G7/DL980 G7 (E7) Memory Cartridges
Five standard PCI-express slots
HP Smart Array P410i/ Zero Memory Controller
Four redundant hot-plug fans
SFF SAS/SATA/SSD drive cage
HP Integrated Lights-Out 3 (iLO 3) management processor: integrated on system board
Rack (4U), 7-inch
NOTE: Power supplies need to be selected separately from Step 2 below
NOTE: If a 2p configuration is selected, then a single -L21 processor kit should be used.
If a 3p configuration is selected, then first processor kit is -L21 and second is -B21. If a
4p configuration is selected, then first processor kit is -L21 and second and third
processor kit is -B21.
NOTE: Intel® Xeon® Processor E7-4800 series processors are supported only in the HP
ProLiant DL580 G7 (E7) Configure-to-order Server (PN 643086-B2x) and E7 series pre-
configured models)
Ten-Core Processors
HP DL580 G7 Intel® Xeon® E7-4870 (2.40GHz/10-core/30MB/130W) FIO 2-processor Kit
NOTE: QPI speed is 6.40 GT/s
HP DL580 G7 Intel® Xeon® E7-4860 (2.26GHz/10-core/24MB/130W) FIO 2-processor Kit
NOTE: QPI speed is 6.40 GT/s
DA - 13669 Worldwide — Version 46 — December 13, 2013
HP ProLiant DL580 Generation 7 (G7)
643086-B21
643086-B22
643067-L21
643069-L21
Page 19