Gigabyte GA-F2A85X-D3H User Manual page 68

B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test). Make
sure OnChip SATA Channel is enabled. To enable RAID for the SATA3 0/1/2/3 connectors, set OnChip SATA
Type to RAID. To enable RAID for the SATA3 4~7 connectors, set OnChip SATA Type to RAID and set OnChip
SATA Port4-7 Type to As SATA Type (Figure 1).
Step 2:
Save changes and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your mother-
board. The actual BIOS Setup menu options you will see shall depend on the motherboard you have
and the BIOS version.
Appendix
Figure 1
- 68 -