Table of Contents
Advertisement
Installing Windows NT
2. If you have only IDE drives, press S. A list box of adapters will be displayed.
Other should be highlighted. Press ENTER. You will be prompted to "Please
insert the disk labeled manufacturer supplied hardware support disk into drive A:.
*Press enter when ready *." Make sure that the Windows NT 4.0 Install Floppy
for the AlphaPC 164UX diskette is in drive A: and press ENTER. A list box will
be displayed. It will contain 2 entries, AlphaPC 164UX PCI Ultra SCSI (Symbios
Logic 53C875), and AlphaPC 164UX PCI IDE (ATAPI). Highlight AlphaPC
164UX PCI IDE (ATAPI). And press ENTER. The next screen displayed will
say "Setup will load support for the following device(s). AlphaPC 164UX PCI
IDE (ATAPI)". Press the ENTER key to continue with setup.
3. If you have a combination of IDE and SCSI drives, press S. A list box of adapters
will be displayed. Other should be highlighted. Press ENTER. You will be
prompted to "Please insert the disk labeled manufacturer supplied hardware sup-
port disk into drive A:. *Press enter when ready *." Make sure that the Windows
NT 4.0 Install Floppy for the AlphaPC 164UX diskette is in drive A: and press
ENTER. A list box will be displayed. It will contain 2 entries, AlphaPC 164UX
PCI Ultra SCSI (Symbios Logic 53C875), and AlphaPC 164UX PCI IDE
(ATAPI). Highlight AlphaPC 164UX PCI Ultra SCSI and press ENTER. The
next screen displayed will say "Setup will load support for the following
device(s). AlphaPC 164UX PCI Ultra SCSI (Symbios Logic 53C875)". Press S.
You will return to the list box of drives with other highlighted. Press ENTER.
You will be prompted to "Please insert the disk labeled manufacturer supplied
hardware support disk into drive A:. *Press enter when ready *." Make sure that
the Windows NT 4.0 Install Floppy for the AlphaPC 164UX diskette is in drive A:
and press ENTER. The list box of AlphaPC 164UX drivers will be displayed
again. Highlight AlphaPC 164UX PCI IDE (ATAPI) and press ENTER. The
next screen displayed will say "Setup will load support for the following
device(s). AlphaPC 164UX PCI Ultra SCSI (Symbios Logic 53C875) and
AlphaPC 164UX PCI IDE (ATAPI)". Press the ENTER key to continue with
setup.
Setup will copy more files. Then it will initialize the kernel. This will be seen as a
blue screen with AlphaPC 164UX in large letters on it. After this a screen titled
"Welcome to Setup" will be displayed. Press ENTER.
The next screen will say "Setup has recognized the following mass storage devices in
your computer." And it will display the drivers you selected off the Windows NT 4.0
Install Floppy for the AlphaPC 164UX diskette earlier. Press ENTER.
Configuring for Windows NT
7–10
Advertisement
Table of Contents
