Equipment; Emission Control - Echo EA-410 Operator's Manual

6

equIpmenT

wArning
Use only ECHO approved attachments. Serious injury may result from the use of a non approved attachment combi-
nation. Read and comply with all safety instructions listed in this operator manual. ECHO, INC. will not be respon-
sible for the failure of attachments or accessories which have not been tested and approved by ECHO.
• Check unit for loose/missing nuts, bolts, and screws. Tighten and/or replace as needed.
• Check that the auger is firmly attached and in safe operating condition.
• Ice blades are very sharp. Wear gloves when handling or replacing.
• Do not use any attachment, accessory, or replacement part unless it is recommended in the Operator's Manual.
• Have repairs done only by an authorized ECHO Service Dealer.
wArning
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all
openings.
• ALWAys stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop
before removing obstructions, clearing debris, or servicing unit.
• DO NOT start or operate unit unless all guards and protective covers are properly assembled to unit.
• NEVER reach into any opening while the engine is running. Moving parts may not be visible through openings.
wArning
Check fuel system for leaks due to fuel tank damage, especially if the unit is dropped. If damage or leaks are found,
do not use unit, otherwise serious personal injury or property damage may occur. Have unit repaired by an autho-
rized servicing dealer before using.
e C
mIssIon onTrol
EPA 2010 and Later and/or C.A.R.B. TIER III
The emission control system for the engine is EM (engine
modification) and, if the second to last character of the Engine
Family on the Emission Control Information label (sample
below) is "C", "K", or "T", the emission control system is EM
and TWC (3-way catalyst). The fuel tank/fuel line emission
control system is EVAP (evaporative emissions). Evaporative
emissions for California models may only be applicable to fuel
tanks.
An Emission Control Label is located on the engine. (This
is an EXAMPLE ONLY, information on label varies by
engine FAMILY).
PRODUCT EMISSION DURABILITY (EMISSION COMPLIANCE PERIOD)
The 300 hour emission compliance period is the time span selected by the manufacturer certifying the engine emis-
sions output meets applicable emissions regulations, provided that approved maintenance procedures are followed as
listed in the Maintenance Section of this manual.
(
&
eXhausT evaporaTIve
)