To Record A Message - Graco RESPOND 2M06 Owner's Manual

900mhz baby monitor
Table of Contents

Advertisement

Available languages

Available languages

To Record a Message

• Turn the Nursery Unit on and set to the desired sound level.
• Slide the "ON/OFF Sensitivity Selector" button on the back of the Nursery Unit to "OFF" and the "Record/Melody
Selector" button on the top of the Nursery Unit to "RECORD".
• Push and hold the "RECORD" button on the back of the Nursery Unit. Record a message up to 15 seconds long. Release
the button when you are done. When the unit beeps, the record time has ended.
To Play back the Message or a Chosen Melody
Your Nursery Unit is equiped with a sensor that will trigger the unit to play either the message or one melody if the volume of
noise around the unit is sufficient to trigger the sensor. There are two settings. When the "ON/OFF Sensitivity Selector"
button on the back of the Nursery Unit is switched to the "LOW" setting, the sensor will detect low sounds near the Nursery
Unit and will trigger the unit to play the message or one melody. The "HIGH" setting will detect only the higher sounds near
the Nursery Unit and trigger the unit to play the message or one melody.
• Turn the Nursery Unit on and set to the desired sound level.
• Slide the "Record/Melody Selector" button on the top of the Nursery Unit to "RECORD".
• Slide the "ON/OFF Sensitivity Selector" button on the back of the Nursery Unit to "LOW" or "HIGH".
• The "Record/Melody Selector" button on the top of the Nursery Unit can also be set to the "MELODY" setting. If the sensor
detects sound, the unit will play one melody and then turn off. If the sound near the Nursery Unit continues, the unit will
play the next melody. This will continue as long as the sensor detects the sound.
• To play music, slide the "ON/OFF Sensitivity Selector" button on the back of the Nursery Unit to "OFF" and the
"Record/Melody Selector" button on the top of the Nursery Unit to "MELODY".
• Press the "PLAY" button no the back of the Nursery Unit. One of four tunes will begin to play. To select a specific tune,
push the "PLAY" button until the desired tune is on. The Nursery Unit will play one song and then shut off automatically.
To Record a Message
Music
6

Advertisement

Table of Contents
loading

Table of Contents