Page 2
Failure to follow these warnings and the assembly instructions could result in serious injury or death. This device is designed only to monitor the sounds of your child. It will not alert you to your child’s silent activities. This product is not designed or intended for use as a medical monitor. Always be sure that both the transmitter and receiver are working properly and are within range of each other.
• To use AC adapters, plug the connector on the cord into the AC adapter jack on the side of the Parent Unit and the Nursery Unit. Then plug adapter into a standard wall outlet. • Use ONLY the Graco adapters included with the unit. Do not use these adapters with other equipment under any circumstances.
• In case you are experiencing some interference, the channel on the Nursery Unit can be changed by switching the channel button on the side of the unit. The Parent Unit and Nursery Unit must both be set to the same channel, either channel “A” or “B”...
To Listen To Baby • Turn on Nursery Unit using the ON/OFF switch. • Turn on Parent Unit using the ON/OFF switch. • Adjust the volume on the Nursery Unit and Parent Unit by turning the Volume Up/Down knob. • The Sound Lights on the Parent Unit will illuminate as your child (or other objects) make noise near the Nursery Unit. Please note that the Sound Lights and volume control on the Parent Unit are independent of each other.
To Record a Message • Turn the Nursery Unit on and set to the desired sound level. • Slide the “ON/OFF Sensitivity Selector” button on the back of the Nursery Unit to “OFF” and the “Record/Melody Selector” button on the top of the Nursery Unit to “RECORD”. •...
DO NOT ATTEMPT to modify the unit. Any modifications to the transmitter and/or receiver can void the operator’s authority to operate the equipment. Most problems have a simple solution. First, check that: • Power is turned ON for both units •...
OFF LOW HIGH PLAY Botón “reproducir” Registro del producto (EE.UU.) Para registrar su producto Graco desde dentro de los EE.UU., visítenos en línea en www.gracobebe.com/productregistration. Actualmente no aceptamos registros de los productos de quienes viven fuera de los Estados Unidos de América.
Page 10
No observar estas advertencias y las instrucciones de armado podría Este dispositivo ha sido diseñado solamente para monitorizar los sonidos de su niño. No le enviará alertas sobre las actividades silenciosas de su niño. Este producto no ha sido diseñado ni debe usarse como un monitor médico. Tenga siempre la seguridad de que el transmisor y el receptor funcionan correctamente y se encuentran a la distancia requerida.
Unidad para padres y la Unidad del dormitorio. Luego enchufe el adaptador en un tomacorriente estándar de la pared. • Use SOLAMENTE los adaptadores Graco que se incluyen con la unidad. No use estos adaptadores con otros equipos en ninguna circunstancia.
•En caso de experimentar alguna interferencia, el canal de la Unidad del dormitorio puede cambiarse oprimiendo el botón “ch” en el costado de la unidad. La Unidad para padres y la Unidad del dormitorio deben usar el mismo canal, el canal “A”...
Page 13
Para escuchar al bebé • Encienda la Unidad del dormitorio usando el interruptor de ENCENDIDO/APAGADO. • Encienda la Unidad para padres usando el interruptor de ENCENDIDO/APAGADO. • Ajuste el volumen en la Unidad del dormitorio y la Unidad para padres girando la perilla para subir y bajar el volumen. •...
Page 14
Para grabar un mensaje • Encienda la Unidad del dormitorio y use el nivel deseado del sonido. • Ponga el botón del “selector de ENCENDIDO/APAGADO de la sensibilidad” atrás de la Unidad del dormitorio a “APAGADO” y el “selector de grabación/melodía” de arriba de la Unidad del dormitorio en “GRABAR”. •...
Page 15
NO INTENTE modificar la unidad. Cualquier modificación al transmisor y/o receptor puede cancelar la autoridad del operador para usar el equipo. La mayoría de los problemas tienen simple solución. Primero, verifique que: • La electricidad esté ENCENDIDA en ambas unidades •...