Echo Instruction Manual Instruction Manual page 16

sTaRTing waRm engine
1. Ensure that there is fuel and chain oil in the tanks. (if fuel tank
was emptied during previous operation, refill tank and push
purge bulb 10 times.)
2. Move chain brake lever fully forward to lock chain brake be-
fore starting.
3. Lay unit on a flat, clear area and keep bar and chain clear of
all obstacles.
4. turn switch (a) to "RUn" position (I).
5. Pull starter handle.
6. Choke may be used if necessary, but be sure to push it back
on first firing sound.
NOTE
if engine does not start after 5 pulls, use cold start procedure.
NOTICE
Do not increase engine speed while chain brake is locked.
severe brake damage will result.
Running
WARNING
the saw chain should not move at idle, otherwise serious
personal injury may result.
NOTE
if saw chain moves, adjust carburetor according to "Carburetor
adjustment" instructions in this manual, or see your dealer.
1. after engine starts, allow it to return to idle.
2. Move chain brake lever fully rearward to unlock chain brake.
3. Press throttle control lockout then gradually squeeze throttle
trigger to increase engine speed.
4. saw chain starts moving when the engine reaches approx-
imately 4,400 rpm.
5. Ensure proper acceleration and lubrication of chain and bar.
6. Do not run the engine at high speed unnecessarily.
7. Be sure that saw chain stops moving when throttle trigger is
released.
sTOPPing
1. Release throttle trigger and turn switch (a) to stOP (O) position.
2. Move chain brake lever fully forward to lock chain brake.
NOTE
if engine does not stop, pull choke out fully to stop engine.
Return the unit to your authorized ECHO dealer to check and
repair stop switch before starting the engine again.
16
A
A