Drive Shaft Lubrication - Echo PE-230 Operator's Manual

Power edger

Hide thumbs Also See for PE-230:

Table of Contents

NOTE

Every unit is run at the factory and the carburetor is set in compli-

ance with emissions regulations. This carburetor does not have

acceleration and high speed adjustment needles.

Check idle speed and reset if necessary. If a tachometer is avail-

able, idle speed screw (A) should be set to the specifications found

on page 9 "Specifications" of this manual. Turn idle screw (A)

clockwise to increase idle speed; counter clockwise to decrease idle

speed.

WARNING

When carburetor adjustment is completed, the cutting attach-

ment should not turn at idle, otherwise serious personal injury

may result.

DRIVE SHAFT LUBRICATION

Level 1.

Tools required: 8 mm Open End Wrench, 4 mm Hex Wrench,

Clean rag

Parts Required: ECHO

Grease.

Loosen two (2) screws (A) and remove center locating screw (B).

Pull gear box and shield from drive shaft housing.

Pull flexible cable from the drive shaft housing, wipe clean and

recoat with a thin coating [15 ml (1/2 oz.)] of grease.

Slide the flexible cable back in the drive housing. DO NOT get

dirt on the flex cable.

Install the gear housing and shield assembly.

DANGER

LUBE

8 oz. (P/N 91014) or Lithium Base

OWER

PERATOR

DGER

ANUAL

Table of Contents