Table of Contents
Advertisement
To interrupt a programme which is running,
press the button 6 : the corresponding green
pilot light starts blinking.
To restart the programme from the point at
which it was interrupted, press the button 6
again . If you have chosen a delayed start,
the machine will begin the countdown.
If an incorrect option is selected, the red pilot
light of the button 6 blinks for 3 times.
Altering an option or a running
programme
It is possible to change some options before
the programme carries them out.
Before you make any change, you must
PAUSE the appliance by pressing the button
6 .
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to O and then to the new pro-
gramme position. Start the new programme
by pressing the button 6 again. The washing
water in the tub will be not emptied out.
Interrupting a programme
Press the button 6 to interrupt a programme
which is running, the corresponding green
pilot light starts blinking.
Press the button again to restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to
gramme which is running.
You can select now a new programme.
Opening the door
After the programme has started (or during
the delay time) the door is locked, if you need
to open it, set first the machine to PAUSE by
pressing the button 6 . After a few minutes
the light 8.2 goes out and it is possible to
open the door.
to cancel a pro-
If this light remains lit and the door is locked,
this means that the machine is already heat-
ing or that the water level is too high. In any
case, do not try to force the door!
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to O . After a few mi-
nutes the door can be opened (pay atten-
tion to the water level and tempera-
ture!) .
After closing the door, it is necessary to se-
lect the programme and options again and to
press button 6 .
At the end of the programme
The machine stops automatically. The pilot
light of button 6 , the pilot lights 8.1 and
8.2 go off. The light 8.3 illuminates.
If a programme or an option that ends with
water left in the tub has been selected, the
pilot light 8.2 remains on and the door is
locked to indicate that the water must be
emptied out before opening the door.
Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to O .
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4. Press button 6 .
At the end of the programme, the light 8.2
goes off to indicate that the door can be now
opened. Turn the programme selector dial to
O to switch the machine off.
Remove the laundry from the drum and care-
fully check that the drum is empty. If you do
not intend to carry out another wash, close
the water tap. Leave the door open to pre-
vent the formation of mildew and unpleasant
smells.
electrolux 9
Advertisement
Table of Contents
