Chapter 2 Configuring The Vip-152T Through Lcd Phone Menu; Initialize Vip-152T - Planet SIP IP Phone User Manual

Configuring the VIP-152T through LCD
1. After any configuration has changed for the VIP-152T, user has to do reboot in the
selection "Reboot".
2. It is suggested to setup IP address via LCD menu Network→Get IP mode / IP Address /
?
Subnet Mask / Default GW first, then go to chapter 3 to do other configurations via web
Note: browser. If user need to do more detail or advanced configurations, please refer to
chapter 4 and use Telnet command lines.
3.
User can also try to enter web configuration via default IP address of VIP-152T:
192.168.0.1

2.1 Initialize VIP-152T

1. After VIP-152T finish initializing, it will get into standby mode:
P2P
The main LCD screen would be shown above. "P2P" means the VIP-152T in Peer-to-Peer
communication mode, and "Proxy" means the VIP-152T is in Proxy Mode.
?
If VIP-152T didn't register to Proxy server, when VIP-152T been off-hook, user will hear busy
Note: tone instead of dial tone, also system LED indication will be blinking.
2. When VIP-152T is under peer-to-peer mode, on LCD will show "P2P" instead of "Proxy".
P2P
PLANET VIP-152T User's Manual
VIP-152T
VIP-152T
10:10:10 AM
7
Chapter 2
Phone menu