Electrolux SG214N User Manual page 19

2
180°
WARNING!
Reposition, level the appliance,
wait for at least four hours and then
connect it to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The edges of the doors run parallel to
the side edge of the appliance.
• The magnetic seal adheres to the cabi-
net.
• The door opens and closes correctly.
WARNING!
If the ambient temperature is cold
(i.e. in Winter), the gasket may not
fit perfectly to the cabinet. In that
case, wait for the natural fitting of
the gasket.
• Remove the door.
• Unscrew and move the pin to the oppo-
site side.
• Re-insert the door.
• Re-screw the lower hinge.
• Raise the appliance and install the venti-
lation grille.
1
• Unscrew the handle. On the opposite
side remove the hole covers by driving a
3-4 mm drift or drill into them.
• Install the handle. Fit the handle on to the
opposite side by turning it on half circle.
• Install the hole covers provided within the
accessory bag.
• Put the cabinet in position.
ENGLISH 19