Personalization; First Use - Electrolux EWF 14380 W User Manual

Display
5.1:
• Duration of selected programme
After selecting a programme, the duration
is displayed in hours and minutes (for ex-
ample 2.05 ). The duration is calculated
automatically on the basis of the maximum
recommended load for each type of fabric.
After the programme has started, the time
remaining is updated every minute.
• Alarm codes
In the event of operating problems, some
alarm codes can be displayed, for example
E20 (see chapter «What to do if...»).
• End of programme
When the programme has finished three
blinking zeros 0.00 are displayed, the Door
pilot light (8.2), the Washing pilot light (8.1)
and the pilot light of button 6 go out and
the door can be opened.
• Incorrect option selection
If an option which is not compatible with
the set wash programme is selected, the

Personalization

Acoustic signals
The machine is provided of an acoustic de-
vice, which sounds in the following cases:
• at the end of the cycle
• in the event of operating problems.
By pressing the 2 and 3 buttons simultane-
ously for about 6 seconds , the acoustic

First use

• Ensure that the electrical and water
connections comply with the installa-
tion instructions.
message Err is displayed for a few sec-
onds and the red pilot light of button 6 light
starts blinking.
• Delay Start
The selected delay set by means of the
relevant button appears on the display for
a few seconds. The delay time value de-
creases by one unit every hour. When only
1 hour remains, the time decreases every
minute.
5.2:
• Heating Phase
During the washing cycle the display
shows a temperature icon (5.2) to indicate
that the appliance has started the heating
phase of the water in the tub. 5.2
5.3:
• Child safety lock
This device permits you to leave the appli-
ance unsupervised without having the
worry that children might be injured by or
cause damage to the appliance. This func-
tion remains able also when the washing
machine is not working.
There are two different ways to set this op-
tion:
– before pressing button 6 : it will be im-
possible to start the machine;
– after having pressed the button 6 : it will
be impossible to change any other pro-
gramme or option.
To enable (disable) this option press simul-
taneously for about 6 seconds 3 and 4
buttons until the symbol 5.3 appears (dis-
appears) on the display.
signal is deactivated (except for the events of
operating problems). By pressing these 2
buttons again, the acoustic signal is reacti-
vated.
• Remove the polystyrene block and
any material from the drum.
• Before the first wash, run a cotton cy-
cle at the highest temperature without
electrolux 7