Basic Troubleshooting; Equalization Settings - Sonos PLAY:1 Product Manual

SONOS PLAY:1

Equalization Settings

The SONOS PLAY:1 ships with the equalization settings preset to provide the optimal playback experience. If desired, you can
change the sound settings (bass, treble, balance, or loudness) to suit your personal preferences.
Note: Balance is only adjustable when the PLAY:1 is used in a stereo pair.
Using a handheld controller, select Settings -> Room Settings.
1.
Touch to select a room.
2.
Select Music Equalization, and then drag your finger across the sliders to make adjustments.
3.
To change the Loudness setting, touch On or Off. (The loudness setting boosts certain frequencies, including bass, to
4.
improve the sound at low volume.)

Basic Troubleshooting

Note: Do not open the device as there is a risk of electric shock. Under no circumstances
should the product be repaired by anyone other than an authorized Sonos repair center, as
this will invalidate the warranty. Please contact Sonos Customer Support for more
information.
If a problem occurs, you can try the troubleshooting suggestions listed below. If one of these doesn't remedy the problem, or
you are not sure how to proceed, please contact the Sonos Customer Support team and we'll be happy to help.
PLAY:1 not detected during setup
A network issue may be preventing the PLAY:1 from connecting to your Sonos system. If this is a wireless PLAY:1, try moving
the Sonos components closer together, or use an Ethernet cable to hard wire the PLAY:1 to your router temporarily to see if
the problem is related to wireless interference.
If you encounter this message while a Sonos component is connected to your router, you can try the steps below to resolve
this issue. If you are still experiencing problems, please contact Sonos Customer Support.
Check the firewall
1.
If you are using a computer, firewall software may be blocking the ports that Sonos uses to operate. First, disable all your
firewalls and try to connect again. If this resolves the problem, you should configure your firewall to work with the Sonos
Controller for Mac or PC. Please go to our Web site at http://faq.sonos.com/firewall for additional information. If this does not
resolve the problem, you can try step 2 below.
Check the router
2.
You can bypass your router's switch to determine whether there are any router configuration issues by connecting a BRIDGE
(or other Sonos component) as depicted in the following illustration (note that the BRIDGE and the computer still have
Internet access in this configuration):
11