46
Cleaning and care
Putting the door glass panels back.
1. From above insert the door glass panels at
an angle into the door profile at the bot-
tom edge of the door one after the other
and lower them.
Insert the smaller panel first, then the larg-
er panel.
2. Take hold of the door trim (B) at each side,
position it on the inside edge of the door
and plug the door trim (B) into the upper
edge of the door
On the open side of the door trim (B) there
is a guide bar (C). This must be pushedThis
must be pushed between the outer door
panel and the guide corner (D).
The clip seal (E) must be snapped in.