Bosch Extractor hood Operating And Installation Manual
  1. Manuals
  2. Brands
  3. Bosch Manuals
  4. Ventilation Hood
  5. extractor hood
  6. Operating and installation manual
Bosch Extractor hood Operating And Installation Manual

Bosch Extractor hood Operating And Installation Manual

Hide thumbs Also See for Extractor hood:
Table of Contents

Advertisement

Quick Links

Operating and
installation instructions
B

Advertisement

Table of Contents
loading

Related Manuals for Bosch Extractor hood

Summary of Contents for Bosch Extractor hood

  • Page 1 Operating and installation instructions...
  • Page 2 Fig. 1 Abb. 1 ELECTRO...

  • Page 3: Table Of Contents

    Table of contents General Information .................... Information on protection of the environment ................Before using the appliance for the first time ..................Safety Instructions ....................Intended use ................................Technical safety ..............................Special information for gas cookers ......................Proper use ................................Correct installation .............................

  • Page 4: General Information

    – WEEE). The directive specifies the Disconnect the extractor hood from the framework for an EU-wide valid mains electricity supply by pulling out the plug return and re-use of old appliances. or switching it off at the main fuse box.

  • Page 5: Safety Instructions

    – or if they do not have the knowledge and experience to operate the appliance RISK OF POISONING correctly and safely. If the extractor hood is operated at the same time as a heating appliance which is Technical safety dependent on ambient air, there is a risk of...

  • Page 6: Special Information For Gas Cookers

    During installation, ensure that only one side of the extractor hood is situated directly next to a high-sided unit or a wall. Otherwise, there is a risk of heat build-up. The gap between the extractor hood and the wall or high-sided unit must be at least 50 mm.

  • Page 7: Proper Use

    Always switch on the extractor hood if a The extractor hood must not be installed hotplate is being used. If the extractor hood is over a solid fuel heating appliance which may not switched on, condensation may form. As a be a fire risk (e.g.

  • Page 8: Operating Modes

    Operating modes An activated carbon filter must be installed to The extractor hood can be used in exhaust bind odours in circulating-air mode (see air and circulating air mode. The standard ”Removing and installing the grease filters”). setting is exhaust air mode.

  • Page 9: Operation

    Operation Light Fan OFF Display for fan setting Fan follow-on Reduce fan speed Fan ON and increase speed Intensive setting NOTE: It is recommended to switch on the Light blower when you start cooking and not to The light can be switched on and off switch it off again until several minutes after you independently of the fan.

  • Page 10: Cleaning And Care

    As the filters become more saturated with NOTE: Observe the warranty regulations in the greasy residue, the flammability increases. The enclosed service booklet. function of the extractor hood may also be impaired. The appliance surfaces and controls are scratch-sensitive. Therefore observe the...

  • Page 11: Removing And Installing The Grease Filters

    Removing and installing the grease filters Before removing and installing the grease Activated carbon filters bind the odours in filters, always follow the instructions and circulating-air mode. warnings in the chapter entitled ”Safety instructions”! Removing and installing the metal-mesh Installing and removing the activated grease filters carbon filters 1.

  • Page 12: Changing The Bulbs

    Changing the bulbs Changing the filament bulbs Before changing the bulbs, always follow the instructions and warnings in the chapter 1. Lift the bulb cover slightly. entitled ”Safety instructions”! 2. Push the bulb cover towards the middle of the appliance. The description of changing the bulbs applies to several appliance models.

  • Page 13: Installation Instructions

    To ensure optimum performance, the extractor hood requires: – a short, straight exhaust air pipe and – the largest possible pipe diameter. Connection of 120 mm ø exhaust air pipe If pipe bends cannot be avoided, ensure the largest possible radii.

  • Page 14: Electrical Connections

    IMPORTANT: Fitting a Different Plug: RISK OF INJURY The wires in the mains lead are coloured in If the power cord of the extractor hood is accordance with the following code: damaged, it must be replaced by the manufacturer, his customer service or a Green and Yellow –...

  • Page 15: Installation

    Installation The extractor hood is designed for Installing the upper support frame installation on the kitchen ceiling or on a rigid 1. Specify the total height of the support suspended ceiling. frame before installation and mark the screw holes. The height of the support During installation, optional accessories may frame can be adjusted in 20 mm steps.

  • Page 16: Attachment

    Installation Installing the lower support frame Installing the extractor hood 1. Hook the extractor hood from below into Attach upper and lower parts of the the support frame. support frame at the specified total height Do not trap the power cord! with 10 screws (preferred hole selection, see diagram).

  • Page 17: Installing The Flue Ducts

    3. Attach both parts of the upper flue to the extractor hood und push together. NOTE: Protect the extractor hood from damage. Avoid scratching the sensitive surfaces. 5. Insert the two lower parts of the flue and push together.
  • Page 18 Notes...
  • Page 19 Notes...
  • Page 20 Notes...
  • Page 21 Notes...
  • Page 22 Notes...
  • Page 23 Accessories DHZ5265 DHZ5285...
  • Page 24 E-Mail: bosch-infoteam@bshg.com Online-Shop: www.bosch-eshop.com 9000 413 920 Printed in Germany 0109 Es...

Table of Contents