Deleting Tpm; Tpm Update; Automatic Scanning Feature Cd Scan - Blaupunkt LONDON RDM 104 Operating Instructions Manual

Deleting TPM

Using the lo/CLR (clear) button, you can
delete single tracks, all of the tracks for one
CD or the entire TPM.
In order to delete any of this information, TPM
must be switched on. TPM will then appear in
the display.
If TPM contains no data, then NO TPM will
appear in the display.
– Deleting a TPM track
• Insert a CD.
• Switch TPM on.
• Select the track with the rocker switch
/ .
• Press the lo/CLR button repeatedly
until CLEAR appears in the display.
– Deleting TPM for one CD
• Insert a CD.
• Switch TPM on.
• Press the lo/CLR button for approxima-
tely 8 seconds until CLR CD appears in
the display.
TPM is now deleted for this CD.
42
– Deleting the entire TPM
• Insert a CD.
• Switch TPM on.
• Press the lo/CLR button for approxima-
tely 14 seconds until CLR TPM ap-
pears in the display.
The entire TPM is now deleted for all of the
CDs.

TPM Update

Use the update function (updates the TPM
memory) to confirm all of the CDs for which
the TPM information is not to be deleted.
• Press the DSC button.
• Use the rocker switch
the CD UPD mode.
• Use the rocker switch <</>> to select
LOAD CD.
• Insert a CD. The following messages
will appear in the display one after the
other: READ CD, READY and after that
NEXT CD.
• Press the button (eject) and remo-
ve the CD.
Proceed as described above for all of the
CDs for which the TPM information is not to
be deleted. Leave the last CD inserted.
• Press the TPM button for longer than 2
seconds.
READY and then CD UPD will then
appear in the display.
In order to exit the DSC mode
• press the DSC button.
The system has saved the information on all
of the CDs which were confirmed. All of the
information for any CDs which were not in-
serted and confirmed beforehand has now
been deleted.
Automatic scanning feature CD
SCAN
Use this function to scan all of the tracks on
any CD.
/ to select Activate SCAN.
• Press PS/MIX for longer than 2 sec.
CD SCAN will then appear in the display.
Portions of the following music tracks will be
played briefly one after the other. If TPM has
been activated, then only those tracks stored
in TPM will be played.
If you would like to listen to the track which is
currently being played,
• press PS/MIX once again.
This will switch SCAN off and the selected
track will be played back.
You can set the playing time from 5 to 30
seconds in the DSC mode under SCAN-
TIME.