Turn Signal Control - Ford Focus Owner's Manual

5. Remove the headlamp bulb cover by releasing the four snap hooks
(two top and two bottom).
Note: On the left headlamp, pull the bulb cover approximately 1 inch
rearward and then slide it out until the vertical aiming adjuster is
accessible.
6. Turn on the low beam to illuminate the wall or screen. On the wall or
screen you will observe an area of high intensity light. If the left side of
each light pattern is not at the reference line, the beam needs to be
adjusted.
7. The adjusting screw has a thumb
wheel that can be operated by hand.
Turn the aiming screw clockwise for
upward movement and
counterclockwise for downward
movement.
Note: HORIZONTAL AIMING IS
NOT REQUIRED FOR THIS
VEHICLE AND IS
NON-ADJUSTABLE.
8. Turn off the headlamp.
9. Attach the headlamp bulb covers.
10. Attach the battery cover and close the hood.

TURN SIGNAL CONTROL

• Push down to activate the left
turn signal.
• Push up to activate the right turn
signal.
2004 Focus (foc)
Owners Guide (post-2002-fmt)
USA English (fus)
Lights
41