Electrolux EWF 840 Instruction Booklet page 16

EWF 1240
7. Select the required options
The light corresponding to the depressed button
illuminates.
8. Select the DELAY START option
To delay starting of the programme, press the
DELAY start button. The figures corresponding to
the selected delay will be displayed for about 3
seconds, after which the duration of the selected
programme will appear on the display.
During this period it is possible to load other laundry:
• depress START/PAUSE button;
• load the laundry;
• close the door and depress START/PAUSE button
again.
9. Start the programme
Press the START/PAUSE button
light will stop flashing, and only the light relevant to
the phase that is in progress will remain lit.
If you have chosen a delayed start, the washing
machine will begin the countdown.
The display will show the duration of the programme
or the selected delay.
10. How to change a programme during
its cycle
Before you make any change, you must pause the
washing machine by pressing the START/PAUSE
button.
It is possible to change any phase before the
programme carries it out.
When the programme has started, you can only
reset it by turning the programme selector dial to
«O» and then you can select the new programme.
The washing water remains in the tub.Start the new
programme by depressing the START/PAUSE
button .
Note: To drain the water before starting the new
cycle you have to cancel the programme and select
the DRAIN cycle.
11. Interrupting a programme
Depress the START/PAUSE button
programme which is running, the corresponding
light starts to flash. Depress the same button again
to restart the programme.
12. Cancelling a programme
Turn the selector dial to O to cancel a programme
which is running. Now you can select a new
programme.
13. Opening the door after the
programme has started
First set the machine to PAUSE by pressing the
START/PAUSE button
If the door does not open, this means that the
machine is already heating, that the water level is
above the bottom edge of the door or that the drum
is turning.
If you cannot open the door but you need to open it
you have to switch the machine off turning
theselector dial to O. After about 3 minutes the door
can be opened (pay attention to the water level and
temperature!). To restart the programme turn the
dial to the previous programme repeating the
options previously selected and press START/
PAUSE button .
16
. The relevant
to interrupt a
.