Jasco 45246 User Manual page 10

10
Channel Selection Switch
The camera will be set to channel 1 from the
factory. To change the camera to channel 2, you
will need to remove the sun shield and unscrew
the lens cover. Locate the channel selector. Slide
the switch to channel 2 and screw on the lens
cover back on until it's snug. Each camera must
be assigned to a specific channel; both cameras
cannot be on the same channel or the signals will
cancel out. If using only one camera you can select
either Ch 1 or Ch 2, whichever provides the best
picture. The slide switch located on the rear of the
Receiver must be set to reflect the channels in use.
Set the receiver to Ch 1, Ch 2, or Ch 1/2. See further
instructions in the receiver section (page 7).