Batteries; Battery Check - C-SCOPE CS4ZX Operating Instructions Manual

CHARGER
SOCKET
in the battery cover (do not fully remove these from the cover) and remove the cover. Inside is the
battery holder. Lift out the holder and detach the connector if it is already fitted. Load it with the
eight batteries ensuring that each battery is inserted the correct way round, (direction of batteries
alternating). Roll each individual battery to ensure it is located correctly and making proper contact.
Replace the connector making sure that it is firm and well seated, and put the loaded holder into the
housing. Fit the cover and tighten the two captive screws finger tight.
Note: Zinc Carbon batteries should not be left in the detector for long periods where they could leak,
so remember to remove them at the end of a day's searching.

BATTERY CHECK

A battery condition indicator is provided on the detector. To do this for the first time prior to reading
the remainder of the operating instructions proceed as follows:- Push the trigger switch (see diagram
3) located underneath the main housing forward, towards the search head. Turn the SENSITIVITY
(POWER) control on. Press the centre toggle switch marked METER DISC GROUND,
BATTERY to BATTERY and hold down. The meter will indicate in the green area if the batteries
are good and in the red or central position if the batteries need replacing or recharging. Release the
switch and turn the SENSITIVITY control off. Rechargeable batteries will not read as high into the
green as standard batteries even when fully charged. They also give less indication of discharge on
the meter during use.
6

BATTERIES

The CS4ZX is powered by
eight
supplied)
garages, department stores,
etc.
rechargeable pack from C-
Scope. It is advisable to use
HEADPHONE
standard batteries to start with.
SOCKET
You can then evaluate the sort
of use you give the detector
and
investment in rechargeables is
justified.
The batteries should be fitted in
the holder which is located in
BATTERY
COMPARTMENT the battery compartment. To fit
new batteries first check the
power switch on the unit is
switched to OFF. Then loosen
the two captive screws located
AA batteries (not
available from
or a single 12v
decide whether the